Can you Epoxy a fishing pole?

Epoxy finish is the key ingredient to crystal-clear thread wraps in custom rod building. But from the thread and epoxy, to the application, curing time and preservation, there are many helpful methods in this blog that you need to ensure your final finish has the perfect appearance!

What kind of epoxy do you use for fishing rods?

Flexcoat rod builders epoxy glue is a high strength, waterproof, clear and unshrinking adhesive. Epoxy is perfect for EVA foam and cork handles. 30 minute setup time allows you plenty of time to get parts positioned properly.

How many coats epoxy fishing rod?

For the most part I always use 2 coats of lite build unless more is needed but there are those times when 3 coats of lite build epoxy my be needed on some rods in order to cover it all or to even cover the guide foot so that the flex of the rod does not crack through the epoxy on the foot of the guide.

Is epoxy a resin?

Epoxy refers to any of the basic components or cured end products of epoxy resins, as well as a colloquial name for the epoxide functional group. Epoxy resins, also known as polyepoxides, are a class of reactive prepolymers and polymers which contain epoxide groups.

You might be interested:  Question: Epoxy Shield How Long Between Base And Clear Coats?

What are fishing rods coated with?

Modern fishing rods are made using fiberglass or carbon fiber sheets. Coated with liquid plastic resin, the sheets are attached at one end of a steel rod called a mandrel. The mandrel is rolled between two heated metal rollers, known as platens, that apply pressure as layers of fiber are wrapped around the mandrel.

How do you speed up epoxy?

Just Use Heat

  1. It is actually possible to make epoxy resin dry faster, just by using heat.
  2. Increase the temperature to 75-85ºF / 24-30ºC in the room where your piece is curing.
  3. The resin reaches 95% of its full cure within 24 hours, and 100% of its cure within 72 hours.

How do you remove epoxy from a fishing rod?

Use a hair dryer on the hot setting, held far enough away not to over heat the rod blank (300° will soften the rod blank). Then use a single edge razor to carefully slice the epoxy covering the inscriptions. Now using a fingernail, peel the epoxy off of the area.

How do you paint a fishing pole?

Steps to Paint a Blank Rod

  1. Step 1: Lightly Sand Rod. When you begin, you will need to use the scuff pad to sand the fishing rod.
  2. Step 2: Wipe Down. After you have sanded the rod, you will want to wipe the rod down with a rag of some sort.
  3. Step 3: Prime.
  4. Step 4: Sand.
  5. Step 5: Paint.
  6. Step 6: Add Clear Coat.

How long does ProKote take to cure?

ProKote ™ High Build will gel in 2-4 hours depending on the ambient temperature and will be fully cured and ready for use in 24 hours. Drying times vary depending on humidity and ambient temperature.

Leave a Reply

Your email address will not be published. Required fields are marked *