What kind of epoxy should I use on wood?

Best Epoxy Resins for Wood in June, 2021

# Epoxy resin
1 Pro Marine Supplies Editor’s Choice Check Price
2 RTG Bar & Table Check Price
3 SRC Crystal Clear Check Price
4 East Coast Check Price


Can you brush epoxy resin on wood?

Pour enough epoxy to cover the edges of the wood as well, wiping up any excess or drips using the foam brush. Using a foam brush to drag the final coat of epoxy over the wood won’t create as even of a surface as a plastic spreader or other hard, flat object.

How do you finish wood with epoxy resin?

  1. Sand the project.
  2. Remove all dust from the project with tack cloth.
  3. Place newspapers or a drop cloth underneath the project.
  4. Pour epoxy resin and hardener into a clean coffee can.
  5. Apply epoxy using a bristle brush.
  6. Check for runs or dry spots as you paint.
  7. Allow project to cure for 24 hours in a dust-free room.

How do you clean wood before epoxy?

Epoxy bonding surfaces must be free of any contaminants such as grease, oil, wax or mold release. Clean contaminated surfaces with lacquer thinner, acetone or another appropriate solvent. Wipe the surface with paper towels before the solvent dries.

You might be interested:  Question: What Do I Use To Reduce Industrial 2 Part Epoxy Primer For Spraying With Hvlp?

How do you keep epoxy from soaking in wood?

The general consensus to seal it with something before pouring the epoxy is correct. I would use a light coat of poly or lacquer, it will easily come off when you sand.

Does epoxy soak into wood?

Straight epoxy should soak into the wood enough to seal it and keep it from getting wet, but won’t add much if any structural value. Cutting your epoxy with solvents is unlikely to work too well; it may thin the resin, but it’ll also weaken it, defeating the purpose.

Can I coat wood with epoxy?

Applying epoxy to wood is the perfect way to showcase both the beauty of the wood grain, and it also gives the wood four times the thickness of a single coat of polyurethane. The best part is that in a few simple steps, you can achieve a beautiful, bubble-free wooden finish.

What finish can I put over epoxy?

Epoxy with two-part polyurethane varnish Two to three coats of epoxy also provide a stable base for clear two-part polyurethane finishes. Applied over epoxy, they perform beautifully together and outlast either coating used by itself.

Can you stain wood after epoxy?

Clear epoxy will sand and scrape down flat, and actually does not penetrate into the wood *grain* deeply. This means you can stain and topcoat it reasonably well after.

What does epoxy do to wood?

Two-part epoxy glue is known for high performance strength and durability. When applied to wood, it acts as a sealant, or filler that hardens to create a lasting bond. Its waterproof seal makes it easy to clean and ideal for wooden tables or furniture. After the full cure time it can be sanded or drilled.

You might be interested:  Question: How To Apply Mapei Epoxy Grout?

Should I stain my wood before epoxy?

It’s not that you are working with epoxy, that goes with any finish. What happens is the dried stain on the surface of the wood doesn’t bond well enough with the wood and the finish adheres to the stain instead of the wood. It’s just never a good idea to put two coats of stain on.

How do you apply epoxy clear coat to wood?

For the best results:

  1. Prepare surfaces scrupulously – make sure your surface is dry, free of dust and other contaminants, and thoroughly abraded.
  2. Use WEST SYSTEM 207 Special Coating Hardener®.
  3. Apply multiple thin coats using a foam roller and tip off the surface after each coat.

Leave a Reply

Your email address will not be published. Required fields are marked *