- 1 How do you use Interlux VC performance epoxy?
- 2 How do I use interlux Interprotect 2000E?
- 3 How do you mix Interprotect 2000E?
- 4 What is a barrier coat on a boat?
- 5 Can interlux perfection be buffed out?
- 6 How do you paint with Interlux Brightside?
- 7 What is 2 part polyurethane?
- 8 How do you use Pettit barrier coat?
- 9 How do you apply marine epoxy paint?
How do you use Interlux VC performance epoxy?
APPLICATION INFORMATION: Apply 3 coats of VC Performance Epoxy. VC Performance Epoxy is designed for spray application but can be applied by brush and rollers. Mix base and curing agent thoroughly at the specified ratio. Allow 45 mins at 50°F/10°C and 30 mins above 77° F/25°C for induction.
How do I use interlux Interprotect 2000E?
Bring the surface to a uniform, clean, bright metal surface with a surface profile of 23 mils (5075 microns). Remove sanding residue and immediately apply a coat of Interprotect 2000E, thinned 1520%. Apply 45 additional coats of Interprotect 2000E.
How do you mix Interprotect 2000E?
Mix three parts of 2000E Base with one part 2001E Reactor and allow it to stand mixed for a minimum of 20 minutes for induction time. Mix only what can be used in five hours. Apply coats of Interprotect to build a total of 10 mils dry film thickness.
What is a barrier coat on a boat?
A barrier coat seals a fiberglass hull, blocking water entry and inhibiting blister formation in underwater gelcoat and fiberglass. If your boat has a fiberglass hull, you MUST protect it with a barrier coat beneath your bottom paint.
Can interlux perfection be buffed out?
Yes, it can be buffed. It can be “color sanded” with extremely fine paper (wet) say 2,500 to 3,000 grit. Or you can use a cutter or a polish.
How do you paint with Interlux Brightside?
Apply 2-3 coats of Brightside, allowing a minimum of 16 hours between coats. Sand between coats with 320-grit sandpaper. Note: Avoid applying late in the day as condensation can cause loss of gloss overnight. In warm or windy conditions, up to 10% Interlux Brushing Liquid 333 may be added to ease application.
What is 2 part polyurethane?
Two – part polyurethanes are pure polyurethanes. Unlike catalyzed finishes, which consist of the finish and an acid catalyst that doesn’t add solids to the film, both parts in 2K polyurethanes add solids. The part that is added is the isocyanate, which usually makes up a quarter to a third of the mix.
How do you use Pettit barrier coat?
Wipe clean of residue and immediately apply one thin coat of Pettit 6455/044 Metal Primer. Let dry 8 hours minimum, 48 hours maximum, and apply three coats * Pettit Protect following application and recoat instructions. coat of 6455/044 Metal Primer and allow to dry eight hours. Apply one coat of Pettit Protect.
How do you apply marine epoxy paint?
Seal the surface with 2-3 coats of Tuff Stuff Epoxy Primer. Apply the first coat of marine epoxy primer and allow the surface to dry to become tacky. Temperature and humidity affect the dry time, but you will know when to apply your next coat of marine epoxy primer once the paint film becomes “tacky”.